Brooks Cinema Series Bass

1) The lower range of audio frequencies up to approximately 250 Hz.
2) Short for Bass Guitar.
3) Lower end of the musical scale. In acoustics, the range (below about 200 Hz) in which there are difficulties, principally in the reproduction of sound, due to the large wavelengths involved.
4) The lower frequencies.
5) On the soundboard this should refer to the bass guitar channel, not the bass drum.
6) The lowest frequencies of sound. Bi-Amplification uses an electronic crossover or line-level amplifiers for the high and low frequency loudspeaker drivers.

Group Faders
The VCA faders of individual channels that are all controlled by a Group Master Fader (a slide control used to send out a control voltage to several VCA faders in individual channels).

Brooks KS-55 Fly In
1) To add sounds into a mix or recording that have no synchronization.
2) An application of this where a performance from one part of a tune is recorded and then recorded back into the recording at a different time in the recording.

Crossover
1) A route leading from one side of the stage to the other, out of the audiences view.
2) An electronic filter in a sound system that routes sound of the correct frequency to the correct part of the speaker system. Different speakers handle high frequencies (tweeters) and low frequencies (woofers). Sometimes known as a crossover network. An active crossover splits the signal from the mixing desk into high, mid and low frequencies which are then sent to three separate amplifiers.
3) An electrical circuit that divides a full bandwidth signal into the desired frequency bands for the loudspeaker components.

Brooks Cinema TX 509 AES/EBU
Professional Interface A standard for sending and receiving digital audio adopted by the Audio Engineering Society and the European Broadcast Union.

Edit
A switch that does different things depending on the operational mode that the machine is in:
1) If a computer-controlled transport is in "Stop," pushing the "Edit" switch deactivates the computer-controlled tension system and allows the reels to be moved by hand to find the exact spot desired on the tape.
2) If the machine is in "Play", the "Edit" switch makes the take-up reel cease taking up the tape and it falls to the floor.
3) If the machine is in a fast-wind mode, the tape lifters are defeated so the tape is in contact with the reproduce head and the engineer can hear where the selections begin and end.

Circuit
1) One complete path of electric current.
2) Similar to definition 1, but including all paths and components to accomplish one function in a device.

Keying Input (Key Input)
An input on a dynamics processing device to control the device by an external audio signal.