Brooks TM-22 Line Out (Output, Send)

Where a signal leaves the board or component.

Cut
1) One selection (one song) on a pre4ecorded music format.
2) A term with the same meaning as Mute (to turn off a channel or a signal).
3) To reduce gain of a particular band of frequencies (with an equalizer).
4) To not pass a particular band of frequencies (said of a filter)

Brooks QS 70 Attack
The rate the sound begins and increases in volume.

Distortion
Usually undesirable result of overloading sound equipment. Reducing the levels can remedy the situation.

Brooks GS 15 Electret Condenser
A condenser microphone that has a permanently polarized (charged) variable capacitor as its sound pressure level sensor.

Basic Session
The First session in recording an audio production to record the Basic Tracks.

Compander
1) A two section device that is used in noise reduction systems. The first section compresses the audio signal, before it is recorded, and the second section, expands the signal after recording.
2) In Yamaha brand digital consoles, a signal processing function that applies both compression and expansion to the same signal.

Bass
1) The lower range of audio frequencies up to approximately 250 Hz.
2) Short for Bass Guitar.
3) Lower end of the musical scale. In acoustics, the range (below about 200 Hz) in which there are difficulties, principally in the reproduction of sound, due to the large wavelengths involved.
4) The lower frequencies.
5) On the soundboard this should refer to the bass guitar channel, not the bass drum.
6) The lowest frequencies of sound. Bi-Amplification uses an electronic crossover or line-level amplifiers for the high and low frequency loudspeaker drivers.