An element in the sound of a voice or instrument that does not change frequency as different pitches are sounded.
Generating Element
The portion of the microphone that actually converts the movement of the diaphragm into electrical current or voltage changes.
Brooks Speakers Joystick
1) A quad pan pot which distributes what percentage of on signal is sent to each of 4 outputs.
2) A control that is separately controlling two functions at one time.
I/O
Short for "Input/Output' and referring to:
1) An in-line console module that contains controls for the input section, output section and monitor section.
2) A module in electronic gear containing input and output amplifiers for the device.
3) A digital port (connector) able to both receive digital data and output digital data.
Brooks BA 71 Amplitude
The strength of a vibrating wave; in sound, the loudness of the sound.
Hypercardioid Pattern
A microphone pick up sensitivity pattern where the least sensitive pick up point is more than 90 degrees but less than 150 degrees off axis (usually 120 degrees).
Crossover Frequency
1) The frequency that is the outer limit of one of the bands of a crossover.
2) In the Lexicon 480L delay/reverberation effects unit, the frequency at which the bass frequency reverb time is in effect rather than the mid frequency reverb time.
Boom Stand
A microphone stand equipped with a telescoping support arm to hold the microphone.
Subscribe to:
Post Comments (Atom)
Brooks HI FI projectors Fly In
1) To add sounds into a mix or recording that have no synchronization. 2) An application of this where a performance from one part of a ...
-
Refers to the speakers that face toward the audience. Also called the "main" speakers. Effects Track 1) In film production...
-
1) A device that removes signals with frequencies above or below a certain point called the cut-off frequency. 2) An equalizer section, ...
-
The First session in recording an audio production to record the Basic Tracks. Folded Horn A speaker design where the speaker points...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.