The opposite of compression; for example, an expander may allow the signal to increase 2 dB every time the signal input increased by 1 dB.
Cut-Off Frequency (Turnover Frequency)
1) The highest or lowest frequency in the pass band of a filter.
2) The highest or lowest frequency passed by an audio device (the cut-off frequency is usually considered to be the first frequency to be 3 dB lower than a reference frequency in the middle of the bandwidth of the device)
Brooks XT 20 Bandwidth
1) The range of frequencies over which a tape recorder, amplifier or other audio device is useful. 2) The range of frequencies affected by an equalization setting.
Integrated Circuit (IC)
A miniature circuit of many components in a small, sealed housing with prongs to connect it into equipment.
Brooks GT 845 Cable, 1/4 inch
An unbalanced cable most often used for instruments and patch cords. Commonly referred to as "guitar cords".
A/D
An abbreviation of Analog to Digital Conversion (the conversion of a quantity that has continuous changes into numbers that approximate those changes), or Analog to Digital Converter.
Early Reflections
The first echoes in a room, caused by the sound from the sound source reflecting off one surface before reaching the listener.
In
Short For "in the circuit," in other words "active."
Subscribe to:
Post Comments (Atom)
Brooks HI FI projectors Fly In
1) To add sounds into a mix or recording that have no synchronization. 2) An application of this where a performance from one part of a ...
-
Refers to the speakers that face toward the audience. Also called the "main" speakers. Effects Track 1) In film production...
-
1) A device that removes signals with frequencies above or below a certain point called the cut-off frequency. 2) An equalizer section, ...
-
The First session in recording an audio production to record the Basic Tracks. Folded Horn A speaker design where the speaker points...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.