Brooks Cinema Projectors Cue

1) The signal fed back to the musicians through headphones.
2) To set the tape or disc so that the intended selection will immediately play when the tape machine or player is started.
3) A location point entered into a computer controlling the playback or recording of a track or tape.
4) In MCI brand tape machines, a term meaning the same thing as Sync Playback (where the record head is used as a playback head for those tracks already recorded).

Crossover Frequency
1) The frequency that is the outer limit of one of the bands of a crossover.
2) In the Lexicon 480L delay/reverberation effects unit, the frequency at which the bass frequency reverb time is in effect rather than the mid frequency reverb time.

Brooks RM 80 Frets
Vertical metal wires which sit vertically on the guitar neck.

Chorus
1) The part of The song that is repeated and has the same music and lyrics each time; the chorus will usually give the point of the song.
2) A musical singing group that has many singers.
3) A delay effect that simulates a vocal chorus by adding several delays with a mild amount of feedback and a medium amount of depth.
4) A similar effect created in some synthesizers by detuning (reducing the pitch of, slightly) and mixing it with the signal that has regular tuning and with a slight delay.

Brooks M 44 Compressor
1) Effect used to squash the sound together. Used properly, it can take the edge off or your sound. Used improperly, it can take the life right out of your system and make it sound like an MTV mix.
2) A piece of sound processing equipment that ensures all wanted signals are suitably placed between the noise and distortion levels of the recording medium. It evens out the unwanted changes in volume you get with close-miking, and in doing so, adds punch to the sound mix. A Limiter is used to stop a signal from exceeding a preset limit. Beyond this limit, the signal level will not increase, no matter how loud the input becomes. A Limiter is often used to protect speaker systems (and human ears) by preventing a system from becoming too loud.

Level
The amount of signal strength; the amplitude, especially the average amplitude.

Impedance
1) A term for the electrical resistance found in a/c circuits. Affects the ability of a cable to transmit low level (e.g. sound) signals over a long distance. Measured in Ohms. Speakers are rated according to power handling capabilities (Watts, W) and impedance (Ohms).
2) The total opposition offered by an electric circuit to the flow of an alternating current of a single frequency. It is a combination of resistance and reactance and is measured in ohms. Remember that a speaker's impedance changes with frequency, it is not a constant value.
3) The opposition to alternating current.

Half Step
A pitch difference of the amount that is present between adjacent keys on a piano.