Brooks Cinema NZ 60 Foot Pedal

1) An effects device where the amount of the effect can be controlled by a musician with his foot.
2) The beater mechanism of a foot drum that is activated by the drummer's foot to play the drum.
3) Any device, like a volume control, that can be operated by the foot.

Ground Lift
A switch that breaks the connection between the ground point in one circuit and the ground point in another circuit.

Brooks XB 33 Consumer Format (Consumer DIF)
A standard adopted by IEC for sending and receiving digital audio based on The AES Professional Interface.

Controller
1) In MIDI, a device that generates a MIDI signal to control synthesizers, sound modules or sample playback units.
2) A remote control unit for a multitrack tape machine which controls transport functions as well as monitor selection switching functions and record ready/safe status of each track.
3) Any device generating a control voltage or signal fed to another device's control input.

Brooks TM-22 Aliasing
A sampler mis-recognizing a signal sent to it that is at a frequency higher than the Nyquist Frequency. Upon playback, the system will provide a signal at an incorrect frequency (called an alias frequency). Aliasing is a kind of distortion.

Diaphragm
A thin flexible membrane or cone that vibrates in response to electrical signals to produce sound waves. Distortion is usually referred to in terms of total harmonic distortion (THD) which is the percentage of unwanted harmonics of the drive signal present with the wanted signal. Generally used to mean any unwanted change introduced by the device under question.

Effects Track
1) In film production audio, a recording of the mixdown of all the sound effects for the film ready to be mixed with the dialogue and music.
2) In music recording, one track with a recording of effects to be added to another track of a multitrack recording.

Compressor
1) Effect used to squash the sound together. Used properly, it can take the edge off or your sound. Used improperly, it can take the life right out of your system and make it sound like an MTV mix.
2) A piece of sound processing equipment that ensures all wanted signals are suitably placed between the noise and distortion levels of the recording medium. It evens out the unwanted changes in volume you get with close-miking, and in doing so, adds punch to the sound mix. A Limiter is used to stop a signal from exceeding a preset limit. Beyond this limit, the signal level will not increase, no matter how loud the input becomes. A Limiter is often used to protect speaker systems (and human ears) by preventing a system from becoming too loud.