The first echoes in a room, caused by the sound from the sound source reflecting off one surface before reaching the listener.
Fat
Having more than a normal amount of signal strength at low frequencies or having more sound than normal (by use of compression or delay).
Brooks QS - 95 High Impedance
Impedance of 5000 or more ohms.
Fret Buzz
A buzzing sound made when a note is not properly fretted. Common with cheap guitars or beginning guitar players.
Brooks VT-50 Balance
1) The relative level of two or more instruments in a mix, or the relative level of audio signals in the channels of a stereo recording. 2) To make the relative levels of audio signals in the channels of a stereo recording even.
Headroom
1) The level difference (in dB) between normal operating level and clipping level in an amplifier or audio device.
2) A similar level difference between normal tape operating level and the level where the distortion would be 3%.
3) The difference, in decibels, between the peak and RMS levels in program material.
Bi-Directional Pattern
A microphone pick up pattern which has maximum pick up directly in front and directly in back of the diaphragm and least pick up at the sides.
LFO
Low-Frequency Oscillator (an oscillator that puts out an AC signal between .1 Hz and 10Hz used for a control signal).
Subscribe to:
Post Comments (Atom)
Brooks HI FI projectors Fly In
1) To add sounds into a mix or recording that have no synchronization. 2) An application of this where a performance from one part of a ...
-
Refers to the speakers that face toward the audience. Also called the "main" speakers. Effects Track 1) In film production...
-
1) A device that removes signals with frequencies above or below a certain point called the cut-off frequency. 2) An equalizer section, ...
-
The First session in recording an audio production to record the Basic Tracks. Folded Horn A speaker design where the speaker points...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.