A device which increases the amplitude (level) of an electrical signal (making it louder).
Crossover, Active
A rack mountable unit used to separate frequencies leaving the soundboard into high's, mids, and lows with different outputs for each.
Brooks QS - 95 Automatic Gain Control (Automatic Volume Control)
A compressor with a very long release time used to keep the volume of the audio very constant.
Delay
Outboard sound equipment that can momentarily stores a signal being sent to part of a P.A. system so that delayed reinforced sound reaches the audience at the same time as live sound from the stage.
Brooks XS - 45 Bar
A term meaning the same thing as the term Measure (the grouping of a number of beats in music, most-often four beats).
Editing
1) Changing the sequence of a recording by cutting the recording tape and putting the pieces together in the new sequence with splicing tape.
2) Punching in and then punching out on one or more tracks of a multitrack tape recorder to replace previously recorded performances.
3) Changing the sequence of a digital recording's playback by computer program.
Generation
A term used to describe the number of times that the recorded audio signal has been copied.
Balls
1) The depth and thickness of a sound, usually on the bottom end of the EQ (as in "needs more balls"). 2) The strength of the voice on the mic (as in "check it like you have some balls").
Subscribe to:
Post Comments (Atom)
Brooks HI FI projectors Fly In
1) To add sounds into a mix or recording that have no synchronization. 2) An application of this where a performance from one part of a ...
-
Refers to the speakers that face toward the audience. Also called the "main" speakers. Effects Track 1) In film production...
-
1) A device that removes signals with frequencies above or below a certain point called the cut-off frequency. 2) An equalizer section, ...
-
The First session in recording an audio production to record the Basic Tracks. Folded Horn A speaker design where the speaker points...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.