Thursday, October 20, 2022

Brooks Audio Design QS 70 Acoustic Echo Chamber

A room designed with very hard, non-parallel surfaces and equipped with a speaker and microphone; dry signals from the console are fed to the speaker and the microphone will have a reverberation of these signals that can be mixed in with the dry signals at the console.

Linear
The condition of obtaining a change at the output of the device which is proportional to the change occurring at the input.

Brooks Cinema XS - 45 Cut-Off Frequency (Turnover Frequency)
1) The highest or lowest frequency in the pass band of a filter.
2) The highest or lowest frequency passed by an audio device (the cut-off frequency is usually considered to be the first frequency to be 3 dB lower than a reference frequency in the middle of the bandwidth of the device)

Limiter
A device which reduces gain when the input voltage exceeds a certain level.

Brooks Cinema GT 845 Bridge
The bridge assembly, or just "bridge" is an area on the face of the guitar where the string meet or are connected to the face.

Group
1) A number of channels or faders that can be controlled by one Master VCA slide.
2) A shortening of the term Recording Group (a buss or the signal present on a buss).

Feedback
1) The delayed signal sent back to the input of a delay line, used in repeat-echo effects.
2) The pickup of the signal out of a channel by its input or the howling sound that this produces.
3) In an amplifier, the phase reversed output signal sent back to its input, reducing gain but also distortion and noise.
4) This occurs when the sound coming out of the speakers goes back into the microphones, then back out the speakers, then back into the mics…and so on. This can build very quickly to a point where everyone in the room is holding their ears and screaming at you. It can also cause damage to the PA.

Chamber
1) An Echo Chamber (a room designed with very hard, non-parallel surfaces equipped with a speaker and microphone so that when dry signals from the console are fed to the speaker, the microphone will have a reverberation of these signals that can be mixed in with the dry signals at the console).
2) A program in a delay/reverb effects device that simulates the sound of an Echo Chamber.

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.

Brooks HI FI projectors Fly In

1) To add sounds into a mix or recording that have no synchronization. 2) An application of this where a performance from one part of a ...