A room designed with very hard, non-parallel surfaces and equipped with a speaker and microphone; dry signals from the console are fed to the speaker and the microphone will have a reverberation of these signals that can be mixed in with the dry signals at the console.
Electricity
Electrical current (the amount of electron charge passing a point in a conductor per unit of time) or voltage (the force pushing electrons to obtain electrical current).
Brooks Audio Design QS 70 Face
The front or body of the guitar.
Line Out (Output, Send)
Where a signal leaves the board or component.
Brooks Audio Design TM-22 Jack
1) Anywhere you plug something in.
2) Segmented audio connector. Mono Jacks have two connections �" tip and sleeve, and are unbalanced. Stereo jacks have three connections �" tip, ring and sleeve. B-type jacks (also known as Bantam jacks) were originally designed for use in telephone exchanges and provide a high quality (and expensive) connection in jackfields. A-type jacks are cheaper and more common, but more fragile. A type jacks are available in 2 sizes : quarter inch and eighth inch.
3) A connector mounted on the case of a device or on a panel.
Full
A quality of the sound of having all frequencies present, especially the low frequencies.
Amplitude
The extreme range of a signal. Usually measured from the average to the extreme.
Limiter
A device which reduces gain when the input voltage exceeds a certain level.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.