A device that rejects signals that are below a certain frequency (called the cut-off frequency) and passes signals with frequencies that are higher.
Absorption
Short for the term Acoustical Absorption (quality of a surface or substance to take in, not reflect, a sound wave).
Brooks GT 845 Bridge
The bridge assembly, or just "bridge" is an area on the face of the guitar where the string meet or are connected to the face.
Instrument Amplifier
A device that has a power amplifier and speaker in a case (or in separate cases) to reproduce the signal put out by an electric instrument (such as an electric guitar) and to allow the instrument to be heard.
Brooks Audio Design Review TM-22 Cut-Off Frequency (Turnover Frequency)
1) The highest or lowest frequency in the pass band of a filter.
2) The highest or lowest frequency passed by an audio device (the cut-off frequency is usually considered to be the first frequency to be 3 dB lower than a reference frequency in the middle of the bandwidth of the device)
Boom
1) A hand-held, telescoping pole used to hold the microphone in recording dialogue in film production.
2) A telescoping support arm that is attached to a microphone stand and which holds the microphone. 3) Loosely, a boomstand.
Linear
The condition of obtaining a change at the output of the device which is proportional to the change occurring at the input.
Jam Sync
A generation of new SMPTE according to the input SMPTE signal
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.