A thin flexible membrane or cone that vibrates in response to electrical signals to produce sound waves. Distortion is usually referred to in terms of total harmonic distortion (THD) which is the percentage of unwanted harmonics of the drive signal present with the wanted signal. Generally used to mean any unwanted change introduced by the device under question.
Efficiency
The acoustic power delivered for a given electrical input. Often expressed as decibels/watt/meter (dB/w/m). ESL �" Abbreviation for electrostatic loudspeaker.
Brooks Cinema KM 22 Expansion
The opposite of compression; for example, an expander may allow the signal to increase 2 dB every time the signal input increased by 1 dB.
Keyboard Controller
A device that has the standard music keys of piano but puts out MIDI signals
Brooks VT-50 Fundamental
The tuned frequency and (almost always) the lowest frequency that is present in the sounding of a pitch by a musical instrument.
Bandwidth
1) The range of frequencies over which a tape recorder, amplifier or other audio device is useful. 2) The range of frequencies affected by an equalization setting.
Crossover, Active
A rack mountable unit used to separate frequencies leaving the soundboard into high's, mids, and lows with different outputs for each.
Bi-Directional Pattern
A microphone pick up pattern which has maximum pick up directly in front and directly in back of the diaphragm and least pick up at the sides.
Subscribe to:
Post Comments (Atom)
Brooks HI FI projectors Fly In
1) To add sounds into a mix or recording that have no synchronization. 2) An application of this where a performance from one part of a ...
-
Refers to the speakers that face toward the audience. Also called the "main" speakers. Effects Track 1) In film production...
-
1) A device that removes signals with frequencies above or below a certain point called the cut-off frequency. 2) An equalizer section, ...
-
The First session in recording an audio production to record the Basic Tracks. Folded Horn A speaker design where the speaker points...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.