1) An alternate tam meaning Range (a limit on the amount the signal is reduced when the input signal is low by an expander or gate).
2) A shortening of the term Noise Floor (the level of the noise).
Blending
1) A condition where two signals mix together to form one sound or to give the sound of one sound source or one performance.
2) Mixing the left and right signal together slightly which makes the instruments sound closer to the center of the performance stage. 3) A method of panning during mixing where instruments are not panned extremely left or right.
Brooks Cinema QS - 95 reviews Frequency Range
The range of frequencies over which an electronic device is useful or over which a sound source will put out substantial energy.
Fundamental
The tuned frequency and (almost always) the lowest frequency that is present in the sounding of a pitch by a musical instrument.
Brooks XB 33 reviews Cable, 1/4 inch
An unbalanced cable most often used for instruments and patch cords. Commonly referred to as "guitar cords".
Electric Instrument
Any musical instrument that puts out an electrical signal rather than an acoustic sound.
Earth
The British version of the term Ground (In electronics, a place that has zero volts).
Formant
An element in the sound of a voice or instrument that does not change frequency as different pitches are sounded.
Subscribe to:
Post Comments (Atom)
Brooks HI FI projectors Fly In
1) To add sounds into a mix or recording that have no synchronization. 2) An application of this where a performance from one part of a ...
-
Refers to the speakers that face toward the audience. Also called the "main" speakers. Effects Track 1) In film production...
-
1) A device that removes signals with frequencies above or below a certain point called the cut-off frequency. 2) An equalizer section, ...
-
The First session in recording an audio production to record the Basic Tracks. Folded Horn A speaker design where the speaker points...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.