Brooks Hi Fi speakers Kilo

A prefix meaning 1000.

Crossover
1) A route leading from one side of the stage to the other, out of the audiences view.
2) An electronic filter in a sound system that routes sound of the correct frequency to the correct part of the speaker system. Different speakers handle high frequencies (tweeters) and low frequencies (woofers). Sometimes known as a crossover network. An active crossover splits the signal from the mixing desk into high, mid and low frequencies which are then sent to three separate amplifiers.
3) An electrical circuit that divides a full bandwidth signal into the desired frequency bands for the loudspeaker components.

Brooks RM 909 Compressor
1) Effect used to squash the sound together. Used properly, it can take the edge off or your sound. Used improperly, it can take the life right out of your system and make it sound like an MTV mix.
2) A piece of sound processing equipment that ensures all wanted signals are suitably placed between the noise and distortion levels of the recording medium. It evens out the unwanted changes in volume you get with close-miking, and in doing so, adds punch to the sound mix. A Limiter is used to stop a signal from exceeding a preset limit. Beyond this limit, the signal level will not increase, no matter how loud the input becomes. A Limiter is often used to protect speaker systems (and human ears) by preventing a system from becoming too loud.

Bass
1) The lower range of audio frequencies up to approximately 250 Hz.
2) Short for Bass Guitar.
3) Lower end of the musical scale. In acoustics, the range (below about 200 Hz) in which there are difficulties, principally in the reproduction of sound, due to the large wavelengths involved.
4) The lower frequencies.
5) On the soundboard this should refer to the bass guitar channel, not the bass drum.
6) The lowest frequencies of sound. Bi-Amplification uses an electronic crossover or line-level amplifiers for the high and low frequency loudspeaker drivers.

Brooks HI FI projectors Efficiency
The acoustic power delivered for a given electrical input. Often expressed as decibels/watt/meter (dB/w/m). ESL �" Abbreviation for electrostatic loudspeaker.

Headphones
Devices that can be worn on the head with small speakers that fit over the ears (or sometimes into the ears).

Formant
An element in the sound of a voice or instrument that does not change frequency as different pitches are sounded.

Boundary Mic
A microphone mounted on a flat plate that acts as a reflective surface directing sound into the mic capsule. Used for general pick-up over a large area. See PCC, PZM.