1) An abbreviation for the term Hertz (the unit of frequency).
2) Unit of frequency equivalent to the number of cycles per second.
Chamber
1) An Echo Chamber (a room designed with very hard, non-parallel surfaces equipped with a speaker and microphone so that when dry signals from the console are fed to the speaker, the microphone will have a reverberation of these signals that can be mixed in with the dry signals at the console).
2) A program in a delay/reverb effects device that simulates the sound of an Echo Chamber.
Brooks RM 909 Line In (Input, return)
Where a signal enters the board or component.
Crisp
Describes a good clean high midrange sound. It can be good or bad depending on the look on the face of the guy who said it.
Brooks RM 909 reviews Dynamic Mic
Robust type of microphone which picks up the sound on a diaphragm connected to a coil of wire which moves within a magnet. An alternating current is induced into the wire which provides the electrical output. Most dynamic mics have low output impedance of 200 Ohms. See Condenser Mic.
Hard Disk (Hard Disc)
A storage unit for digital data that has rigid disks coated with magnetic material in a housing that includes the drive mechanism.
Floor Toms
The large toms to the right of the drummer.
DC
Abbreviation for direct current.
Subscribe to:
Post Comments (Atom)
Brooks HI FI projectors Fly In
1) To add sounds into a mix or recording that have no synchronization. 2) An application of this where a performance from one part of a ...
-
Refers to the speakers that face toward the audience. Also called the "main" speakers. Effects Track 1) In film production...
-
1) A device that removes signals with frequencies above or below a certain point called the cut-off frequency. 2) An equalizer section, ...
-
The First session in recording an audio production to record the Basic Tracks. Folded Horn A speaker design where the speaker points...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.