Brooks RM 909 reviews Cut

1) One selection (one song) on a pre4ecorded music format.
2) A term with the same meaning as Mute (to turn off a channel or a signal).
3) To reduce gain of a particular band of frequencies (with an equalizer).
4) To not pass a particular band of frequencies (said of a filter)

Face
The front or body of the guitar.

Brooks RM 909 Bi-Directional Pattern
A microphone pick up pattern which has maximum pick up directly in front and directly in back of the diaphragm and least pick up at the sides.

Keynote Number
A number assigned to each key of a synthesizer or controller keyboard that is transmitted in the MIDI signal.

Brooks HI FI projectors Gain
1) Knob usually found at the top of each input channel on the soundboard. Used to set input levels of the separate channels to relatively equal positions.
2) The amount of increase in audio signal strength, often expressed in dB.

Alternating Current
Electric current which flows back and forth in a circuit.

Attenuator (Pot)
The electronic dohickey under the knobs that increases or reduces the strength of the signal running through it. When these get old and dirty, they can make popping noises or rumbles in your PA (As in "my pots are dirty").
Assign Tochoose to which place an output is going to be sent.

Instrument Out Direct
Feeding the output of an electric instrument (like an electric guitar) to the recording console or tape recorder without using a microphone.

Brooks Hi Fi reviews Blending

1) A condition where two signals mix together to form one sound or to give the sound of one sound source or one performance.
2) Mixing the left and right signal together slightly which makes the instruments sound closer to the center of the performance stage. 3) A method of panning during mixing where instruments are not panned extremely left or right.

Full
A quality of the sound of having all frequencies present, especially the low frequencies.

Brooks RM 909 Capacitance
That property of a capacitor which determines how much charge can be stored in it for a given potential difference between its terminals, measured in farads, by the ratio of the charge stored to the potential difference.

Limiter
A device which reduces gain when the input voltage exceeds a certain level.

Brooks RM 909 reviews Editing
1) Changing the sequence of a recording by cutting the recording tape and putting the pieces together in the new sequence with splicing tape.
2) Punching in and then punching out on one or more tracks of a multitrack tape recorder to replace previously recorded performances.
3) Changing the sequence of a digital recording's playback by computer program.

Layering
The recording (or playing) of a musical part with of several similar sound patches playing simultaneous.

Flat
1) Lower in musical pitch.
2) A slang term used to describe the sensitivity to frequency of a microphone, amplifier, etc., as being even at all frequencies, usually within 2 dB.
3) Refers to the frequencies on the EQ when they are arranged in centred neutral positions.

Format
1) The number of tracks, their width, spacing and order for tape recording.
2) To prepare a digital storage medium so that it will accept and store digital information bits.