The control on a delay line or delay effects device that controls the amount of feedback.
Crossover, Passive
Used inside of full range speaker cabinets to separate highs, mids, and lows and send them to their respective speakers within the each cabinet. These are not as efficient as active crossovers because they require all frequencies to draw from the same source of amplification.
Brooks Cinema TX 509 Capacitor
1) A device consisting of two or more conducting plates separated from one another by an insulating material and used for storing an electrical charge. Sometimes called a condenser.
2) An electronic device that is composed of two plates separated by an insulator.
Early Reflections
The first echoes in a room, caused by the sound from the sound source reflecting off one surface before reaching the listener.
Brooks Cinema xm 808 Kilo
A prefix meaning 1000.
Balance
1) The relative level of two or more instruments in a mix, or the relative level of audio signals in the channels of a stereo recording. 2) To make the relative levels of audio signals in the channels of a stereo recording even.
Amplitude
The extreme range of a signal. Usually measured from the average to the extreme.
Hearing Limitation
An inability of the ear to hear important characteristics of sound under certain conditions. Characteristics that can be affected include pitch, level, clarity, presence and direction.
Subscribe to:
Post Comments (Atom)
Brooks Hi Fi speakers Filter
1) A device that removes signals with frequencies above or below a certain point called the cut-off frequency. 2) An equalizer section, ...
-
Refers to the speakers that face toward the audience. Also called the "main" speakers. Effects Track 1) In film production...
-
A double cymbal on a stand which can be played with a foot pedal or by the top cymbal being hit with a stick. Amplifier (Power amp, He...
-
An input on a dynamics processing device to control the device by an external audio signal. Ground In electronics, a place (terminal...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.